15Ga0.85As/GaAs/AlGaAs

step QWs. For an undoped QWs with high crystal quality, the excitonic effect will play a dominant role in the photocurrent spectra. In this case, both of the electron and holes will contribute to the photocurrent [25]. We separate the CPGE spectra induced by Rashba and Dresselhaus spin splitting, respectively, and we find that the Rashba- and Dresselhaus-induced CPGE spectra are quite similar with each other during the spectral region corresponding to the transition of the excitonic state 1H1E (the first ROCK inhibitor valence subband of heavy hole to the first conduction subband of electrons). The ratio of the CPGE current induced by Rashba and Dresselhaus spin splitting for the transition of 1H1E is much larger than that in the symmetric QWs reported in our previous work (i.e., 8.8 vs 4.95). Although the reduced well width enhances the Dresselhaus-type spin splitting compared to the symmetric QWs, the ARRY-438162 in vivo www.selleckchem.com/products/4egi-1.html Rashba-type spin splitting in the asymmetry step QWs increases more rapidly. By using reflectance-difference spectrum and photoreflectance spectrum, we find that the degree of the segregation effect of indium atom and the intensity of the build-in field in the step QWs are comparable to those in symmetric QWs. So, the larger Rashba SOC may be mainly induced by the one more interface present in the step structures. Methods The sample

studied here is asymmetric In0.15Ga0.85As/GaAs/Al0.3Ga0.7As step QWs grown on (001) SI-GaAs substrate by molecular beam epitaxy. After a 2,000-Å buffer layer is grown, ten periods of 50 Å- In0.15Ga0.85As/50 Å-GaAs/100 Å- Al0.3Ga0.7As are grown. The grown temperature of In0.15Ga0.85As and Al0.3Ga0.7As are 540°C and 580°C, respectively. Then, 500-Å-thick Al0.3Ga0.7As layer and 100-Å GaAs cap layer are deposited. All epilayers are intentionally undoped and the InGaAs layers are fully strained since their thickness Celecoxib is far below the critical thickness.

The sample is cleaved along [110] and [1 0] (denoted as the x ′ and y ′ directions, respectively) into a square of 5 mm × 5 mm with four pairs of ohmic contacts 4 mm apart along the x ′, y ′ and diagonal directions, respectively, as shown in figure one(a) in [26]. The ohmic contacts are made by indium deposition and annealed at about 420°C in nitrogen atmosphere. For optical inter-band excitation, a supercontinuum laser source combined with a monochromator is used providing radiation of wavelength in the range between 800 and 950 nm. The supercontinuum laser provides 5-ps pulses with a repetition rate of 40 MHz and an average power of 4 W. Then, the monochromatic light with a linewidth of 1.5 nm goes through a polarizer and a photoelastic modulator (PEM) to yield a periodically oscillating polarization between right (σ -)- and left (σ +)-hand circularly polarized light. The light spot on the sample is rectangular of 2 × 3.